MS
S Mahadevan
Indira Gandhi Centre for Atomic Research
Research areas: Engineering · Mechanical Engineering · Microstructure and Mechanical Properties of Steels · Non-Destructive Testing Techniques · Welding Techniques and Residual Stresses
0000-0002-0274-7381
Employment
-
Indira Gandhi Centre for Atomic Research Scientific Officer2002 - 2026
Education
Education history is unavailable.
Projects & Funding
Projects & funding information is unavailable.
Publications (60)
- Introduction to the ENDE 2024 special issue Save
- An approach for identifying the deformation-induced strain from tensile tests and x-ray diffraction measurements Save
- Corrigendum to “Influence of strain rate, temperature, and strain-induced martensite on residual stress evolution during tensile deformation of SS 304L” [Mater. Today Commun. 42 (2025) 111294](S2352492824032768)(10.1016/j.mtcomm.2024.111294) Save
- Influence of strain rate, temperature, and strain-induced martensite on residual stress evolution during tensile deformation of SS 304L Save
- An equivalent circuit approach for remnant thickness evaluation and flaw sizing using pulsed thermography Save
- Tensile and Low Cycle Fatigue Response of SS321 at Room Temperature Save
- A Study on the Scan Plans for Rapid Flaw Detection by Eddy Current Non-Destructive Evaluation Save
- Failure Analysis of Large Stroke Welded Disk Bellows in Storage Save
- Influence of Heat Treatment Condition on Tensile Properties of AM350 Stainless Steel Save
- Load partitioning behavior in a metastable austenitic stainless steel subjected to pre-deformation below and above Md temperature: Experimental and modeling studies Save
- Acoustic Emission during Press-Brake Bending of SS 304L Sheets and its Correlation with Residual Stress Distribution after Bending Save
- Influence of Hardening Models on the Estimation of Residual Stresses by Finite Element Modeling in Type 316LN Stainless Steel Weld Joints Save
- Studies on Residual Stress and Distortion Prediction of Lattice Structures in Powder Bed Fusion of Alloy 625 Save
- Influence of prior deformation temperature on strain induced martensite formation and its effect on the tensile strengthening behaviour of type 304 SS studied by XRDLPA Save
- On the interaction of microstructural morphology with residual stress in fiber laser welding of austenitic stainless steel Save
- An improved quality assessment of fuel pin end plug welds using digital X-ray radiography Save
- Effect of cutting process on the stress corrosion susceptibility of AISI 304L stainless steel Save
- Correlation of Tensile Deformation-Induced Strain in HSLA Steel with Residual Stress Distribution Save
- Failure Analysis of Motorized Bellow-Sealed Valve of Sodium Loop in Fast Breeder Test Reactor Save
- Numerical Simulation and Experimental Validation of A-TIG Welding of 2.25Cr–1Mo Steel Save