AB
Andrea Ballo
University of Catania
Research areas: Engineering · Electrical and Electronic Engineering · Analog and Mixed-Signal Circuit Design · Low-power high-performance VLSI design · Advanced DC-DC Converters
Employment
-
University of Catania Research fellow2020 - Present
Education
-
University of Catania Master's degree in electronic engineering2013 - 2016
-
University of Catania Bachelor's degree in electronic engineering2009 - 2013
Projects & Funding
Projects & funding information is unavailable.
Publications (63)
- Experimental Analysis of Electro-Thermal Gradient Effects in Monolithic LDO Regulators Save
- Monolithic Intrinsic-Capacitance Bootstrapped Inverter in E-Mode GaN-on-SOI: Design, Analysis, and Electro-Thermal Characterization Save
- A 0.15-to-0.9-V V IN Cross-Coupled Charge Pump With Dynamic Leakage Suppression and Frequency Scaling Ring Oscillator Scoring >650-mV Voltage Dynamic Range in 65-nm CMOS Save
- Automated Electrorotation System for High-Throughput Dielectric Cell Characterization Save
- RF/mm-Wave Frequency Doublers in CMOS Technology Save
- A 65-nm Fully Integrated Reconfigurable Charge Pump With Joint Optimization of Conduction and Switching Losses for Micro-Energy Harvesting Applications Save
- Area-Efficient Low-Power Self-Biased Three-Stage OTA Fabricated in 0.6-μm IGZO-on-Plastic Technology Save
- Investigating a CNT-based Dickson charge pump with linearly distributed capacitance working in FSL Save
- Capacitance Distribution in Charge Pumps With Capacitive Load to Reduce Area and Input Energy Save
- A 28-nm CMOS Low-Power/Low-Voltage 60-GHz LNA for High-Speed Communication Save
- Sub- μ W Battery-Less and Oscillator-Less Wi-Fi Backscattering Transmitter Reusing RF Signal for Harvesting, Communications, and Motion Detection Save
- Bulk-Driven CMOS Differential Stages for Ultra-Low-Voltage Ultra-Low-Power Operational Transconductance Amplifiers: A Comparative Analysis Save
- 46-nA High-PSR CMOS Buffered Voltage Reference With 1.2–5 V and −40 ◦C to 125 ◦C Operating Range Save
- 0.4-V nW-Power High-Gain Bulk-Driven Two-Stage OTA With Self-Cascode Composite Transistors and Intrinsic Current-Buffer Miller Compensation Save
- Ultra-Low-VIN Dual-Dimensional Reconfigurable Charge Pump With Enhanced Power Conversion Efficiency and Extended Power Dynamic Range for Micro-Energy Harvesting Applications Save
- A 5 mW 28 nm CMOS Low-Noise Amplifier with Transformer-Based Electrostatic Discharge Protection for 60 GHz Applications Save
- A Current-Efficient Pseudo-3D Regulated Dickson Charge Pump Save
- 0.35-V SR-Enhanced Bulk-Driven OTA for Loads up to 10 nF Save
- 0.6-V, μW-Power Four-Stage OTA With Minimal Components, and 100× Load Range Save
- A High Efficiency and High Power Density Active AC/DC Converter for Battery-Less US-Powered IMDs in a 28-nm CMOS Technology Save